This guide will go through the setup of the AirServer Connect device for the first time.
Quick setup
Turn on AirServer Connect device by pressing the power button. To start the configuration follow the on-screen instructions.
If the AirServer Connect is connected to a network using an Ethernet cable, Quick Setup can be done through a web browser on a computer or mobile device on the same network. Type in the IP address shown in the instructions and at the bottom left of the homescreen. Once the Device Management page has loaded, type in the setup PIN to get started.
If the AirServer Connect is not connected using an Ethernet cable, you must first connect a computer or a mobile device to the Guest Wi-Fi shown in the Guest Access section on the on-screen menu. You can then type the IP address shown in the instructions into your browser to start the Quick Setup.
The Quick Setup guides you through the basic settings for the AirServer Connect:
- Password protection for Device Management
- Device/Room name
- Homescreen layout
- Country
- Language
- Timezone
- Screen mirroring preferences
Once setup is completed, all settings can be accessed by selecting Advanced Settings. The on-screen display will no longer show the Quick Setup instructions.
It is recommended to log into advanced settings and check for updates in the Updates section, as new firmware may be available. Firmware release notes can be found here.