All AirServer Connect devices have this functionality enabled by default, so that the device automatically boots up when it receives power.

This setting can be changed in the device’s BIOS, where you can configure the power-state the device should enter when power is restored.


Connect 3 device
During startup:
  1. Make sure to power off AirServer Connect first.
  2. Connect a USB keyboard.
  3. Power on AirServer Connect and keep pressing R until a boot menu appears.
  4. Choose "Reboot Into Firmware Interface".
  5. Go to Chipset -> PCH Configuration -> Restore AC Power Loss and select the desired option


Connect 2 device
During startup:
  1. Make sure to power off AirServer Connect first.
  2. Connect a USB keyboard.
  3. Power on AirServer Connect and keep pressing R until a boot menu appears.
  4. Choose "Reboot Into Firmware Interface".
  5. Go to Advanced -> Restore AC Power Loss and select the desired option


Connect 1 device
During startup:
  1. Make sure to power off AirServer Connect first.
  2. Connect a USB keyboard.
  3. Power on AirServer Connect and keep pressing R until a boot menu appears.
  4. Choose "Reboot Into Firmware Interface".
  5. Go to Power ->  Secondary Power Settings -> After Power Failure and select the desired option